Water Eject: Eject Water From Your Speaker
A muffled speaker after a splash is frustrating, especially when you want to check it right away. This water eject sound may help move droplets at the speaker grille. First disconnect cables, dry the outside and point the speaker down; play the tone only through the phone's built-in speaker.
Keep the result in perspective. Clearer sound would tell you something about the speaker, but it would not prove the inside of the phone or the charging port is dry. Give drying time priority over another run of the tone.
Start with the wet-phone basics
Remove the phone from water, disconnect any cable and dry its exterior with a clean, soft cloth. For a phone that was dropped in water, Google’s Pixel guidance says to turn it off, dry it with a soft cloth and leave it on a flat surface at room temperature. Samsung likewise notes that water in a speaker can affect audio and advises drying the speaker area with a clean, soft cloth.
- Remove the case, charging cable and headphones.
- Turn off Bluetooth so sound is not routed to another device.
- Hold the phone with the affected speaker facing down toward a dry cloth.
- Start the sound at a comfortable volume. Stop if distortion gets worse or the phone behaves unusually.
What this water eject sound can do
The tone plays through the built-in speaker continuously until you press Stop. Speaker vibration may help surface droplets move away from the grille, especially while gravity is helping. That is the narrow job of this tool.
It cannot clear a wet USB-C or Lightning connector, draw liquid out of sealed parts or reverse corrosion. Apple’s Water Lock instructions for Apple Watch confirm that a series of tones is used to clear water remaining in that watch’s speaker; that does not mean every phone or every kind of liquid exposure will respond the same way.
Keep a wet charging port separate from a wet speaker
Do not use this sound as a reason to reconnect a wet charging cable. Apple says to disconnect the cable when a liquid-detection alert appears and wait until the iPhone and cable are completely dry before reconnecting. It advises waiting at least 30 minutes before trying again and notes that complete drying can take up to 24 hours.
Do not use external heat, compressed air, rice, or objects pushed into the port or speaker mesh. See Apple’s liquid-detection guidance for the full iPhone-specific instructions. For another make or model, follow that manufacturer’s own support advice.
When a quieter speaker needs more than a tone
Water can be one reason a speaker sounds quiet, crackly or distorted, but it is not the only one. Samsung recommends first removing accessories and disabling Bluetooth, because audio can be redirected to another output. Remove any case or film that covers an opening and test ordinary audio after the phone has had time to dry.
Turn the phone off and contact the manufacturer or a qualified repair provider if it was submerged, exposed to salt water or another contaminant, will not charge after drying, overheats, restarts unexpectedly, or remains distorted after it has dried. Water resistance reduces risk; it is not a guarantee against water damage. Once dry, use the mobile diagnostic tools to check other browser-supported phone features.
Manufacturer guidance used on this page
- If you see a liquid-detection alert on your iPhone, Apple Support.
- Help prevent water damage to your Pixel phone, Google Pixel Help.
- Speaker does not work properly on Samsung phone, Samsung Support.
This page generates a browser tone, not a manufacturer diagnostic. Follow your own device maker’s instructions when they differ.